GO Jiaju teaches you how to solve the problem of paint

Paint in the decoration is inevitable, this is also a matter of careful work, the quality of the paint also determines the beauty of the entire wall. If you experience sudden symptoms, then GO Jiaju teaches you how to solve the paint.

Symptom 1: The coating cracks and falls off

Cause: The early appearance of the coating showed cracks like hair strands. In the later stage, exfoliation occurred. Most of them used coatings with poor adhesion and flexibility, excessive dilution or covering coating, wall or base surface pretreatment. Sufficient, the coating film is excessively hardened and embrittled after aging.

Recommendation: Use a spatula or wire brush to remove loose and peeling paint, sand the surface and trim. If peeling occurs on multiple coats, water-resistant putty should be used if necessary. The primer should be sealed before recoating. The use of high quality primers and topcoats can prevent recurrence of such problems. Do not over dilute the coating with water.

Symptom 2: mildew

Cause: Black, gray, or brown spots appearing on the surface of a paint or wall where it is wet, has little light, or is out of direct sunlight. The mold spots on the substrate or coating were not cleaned before using inferior emulsion paint or before painting.

Recommendation: Drop a few drops of household bleach in the place where the color is changed to check for the presence of mold. If the stain disappears, it may be mold. Rinse the surface with a diluted household bleach solution (one bleach to three parts water) to thoroughly remove mold and wash thoroughly with rubber gloves and goggles while working. In order to avoid mold on the wall, use a high-quality latex paint from a regular manufacturer, wash the base with a bleach/detergent solution if necessary, and consider installing an exhaust fan in a high humidity area.

Symptom 3: Coating wrinkles

Cause: The paint was applied too thickly at the time of painting, and the surface of the paint film became rough and wrinkled. Brushing in very hot or cold weather can cause the surface of the film to dry faster than the underlying layer or expose the uncured film to an excessively humid environment.

Recommendation: Scrap or polish the surface of the substrate to remove the wrinkled coating. If a primer is applied, make sure the primer is completely dry before applying the topcoat. When repainting (avoid extreme temperature and humidity), apply a layer of high quality interior paint evenly. Symptom 4: Coating yellowing

Reason: Ordinary coatings are often exposed to sunlight. From the furnace, heating, heating pipes or other materials, it is prone to yellowing discoloration due to UV aging and other substances.

Recommendation: For places with strong sunlight or pollution, it is recommended to use high-quality latex paint with anti-aging and light resistance for decoration.

Editor in charge: Shanghai GO Jiaju

Guanyu Bathroom is a Foshan, GD base manufacturer of reliable luxury bathroom fixtures such as bathroom furniture, steam showers, whirlpool bathtubs, stainless steel Shower Panel, acryllc Bathtub, shower cublcle and shower tray.

High Quality Acrylic & Tempered Glass Bathtub / Low-Noise Design Function Indoor Bathtub / Creepage Protection Design Air Bubble Massage Bathtub


Why Guanyu???

There are lots of reasons to think Guanyu is the best luxury bathroom manufacturer in the world. Our Bathroom Furinture is manufactured using a high-density waterproof oak and all of our shower, steam rooms, whirlpool bathtubs are manufactured using a unique form superior acryllc that you will not find any of competitors products. All of our products are built from ground up for reliability. Once our products are manufactured, we perform more quality assurance that anyone else in the industry. Each unit is individually tested and hand inspected before it is shipped. We are so confident in the reliability of our products are healthy for the mind and body.

Our Mission: To provide outstanding bathroom products that our customers love for their reliablility, functionality, and style.


Top Grade Acrylic & Temper Glass Bathtub

Top Quality Two Person Massage Bathtub


Two Person Sector Comfortable Massage Bathtub

Single Person Massage Indoor Bathtub

Please kindly contact us for further details if you are interested, thank you very much!


Glass Bathtub

Glass Bathtub,Water Massage Glass Indoor Bathtub,Human-Oriented Design Glass Tub

Foshan Guanyu Group , https://www.guanyu-group.com

Posted on