When rookie decoration, workers are often asked to help install toilets and stand next to them as if they were supervisors. In fact, they do not understand anything. If workers have acts of cutting corners and materials, they will certainly bring great inconvenience to their use in the future.
In fact, the installation process of the toilet is very critical, and the acceptance is also very particular, and you can't just look at the final result. As long as we allow workers to carry out the construction according to the specifications during the installation process, we will be able to avoid hidden dangers in the future. Let's take a look at the standard installation procedure for commode.
(1) Take out the pipe plug of the ground water outlet, and check that there is no debris in the pipe. Clean the area around the nozzle.
(2) Align the outlet pipe of the toilet with the outlet pipe, place it flat, and draw a mark on the hole of the toilet bolt and remove the toilet.
(3) Insert a hole with a diameter of 20 mm and a depth of 60 mm at the imprint, insert a 10 mm diameter bolt into the hole, secure it with cement, align the eye of the toilet with the bolt, align it with the mark, and after the test, The toilet was removed. Put putty around the outlet of the toilet bowl and the nozzle of the water pipe, and then align the four bolt holes of the toilet with the bolt, lay it flat and align it. Put a rubber pad on the bolt and screw it on until the nut is tight.
(4) Align the back center of the toilet and draw a vertical line. Draw a horizontal line at a height of 800 mm from the ground. Draw a seal on the horizontal line according to the positions of the two side holes on the back of the tank. Play a diameter of 30 mm at the hole. 70 mm hole. Insert a bolt 10 mm in diameter and 100 mm in length into the hole and secure it with cement. Hang the back water tank on the bolts, align and align them, especially align with the center of the toilet bowl. Put a good rubber pad on the bolts, screw on the nuts, and tighten them to a moderate degree.
(5) When installing the backwater tank elbow, first remove the nuts of the backwater tank water outlet and the toilet water inlet, and put it back to back on the water elbow. The rubber pads are also placed on the sewage pipe. Insert the upper end of the water elbow into the drain of the back tank, insert the lower end into the water inlet of the toilet, push the pad to the nozzle, screw on the nut, straighten the water elbow and straighten it, and tighten it with the pliers. Moderate.
(6) When connecting the upper water with the eight-character door, the size of the water tank's drift gate should be measured firstly, and the short section should be prepared. The eight-character door should be installed, and the water inlet pipe should be installed. If the Copper tube or plastic tube is cut off, it is necessary to use the mother of the lamp fork to bend the mother. Then the back of the drifting door and the eight-word door nut are put back on the copper tube or the plastic tube, and the tube is wrapped with oil-wool asbestos rope or lead-oil twine. Insert the drift door and eight-word door entrance and exit, tighten the nut.
Entrance decoration restaurant decoration cement
Luminated Aluminum Sheet,Mill Finish Aluminum Sheet,Thin Aluminum Sheets
Ling Feng Aluminum Co., Ltd. , http://www.nbaluminum.com